.1 to 2 oz Compressor Oil Dye Injector AC/HVAC 1/4" FFL
You are looking at a brand new
2 oz Oil and/or Dye Injector , for AC/HVAC/R Services
Answer: Compressor oil in the compressor of any refrigeration systems, get pumped out along the refrigerant through the whole line of refrigerant, and get to a "balance" if the return of the refrigerant to the compressor is not restricted and the suction line is configured right. Other wise the compressor may run out of compressor oil. Replacement of a major part, like a condenser or evaporator in a refrigeration system, or even a dryer/filter, may remove a big part of the compressor oil with the replaced part. In these cases, compressor oil may need to be added to the system. Compressors running short of compressor oil are likely to over-heat and add wearing to the compressor and may short the life of the compressor.
How the compressor oil is added?
Answer: Use an Oil injector like this one, add the oil to the cylinder and hook it up to the the service port(make sure air is eliminated before injecting the oil). Squeeze it in when you screw-down the injector. Note: its easier to load the oil from the Low side is the system is running. Watch the oil level if the compressor has a sight-glass. Never over load the compressor or refrigeration system with compressor oil.
WE DO NOT SELL ANY THING THAT is supposed TO WORK,
* 0.1 to 2 oz oil capacity, graduated on the side of the inner cylinder.
* (6 oz capacity injector available, see model: OI2)
* Compatible with fluorescent dyes for leak monitoring, too
* Compatible with all oil types(POE, or mineral oil)
* Re-loadable, re-usable, keep it in tool box for decades to come.
* Aluminum alloy body, BUILT tough with brass connector.
* 1/4" female connector, make it compatible with most AC systems.
* 5 inch flexible high pressure hose.
* Hand operated(Screw-down), NOT in-line injector, do not need other power.
WE SUPPLY HVAC SCHOOLS AND CONTRACTORS!
