Iowa-Industrial Moderated Mailing List -- Current and Archive   >   Cedar Rapids   >   Welding and Soldering   >   Arc Welding   >   TIG Tungsten Inert gas   >   Branson ipc L3200 from ALLWIN21

Branson ipc L3200 from ALLWIN21


Poster: 754706727@iowa-industrial.com

Branson ipc L3200 from ALLWIN21

Branson/IPC L3200 single wafer downstream stripper
* Dual quartz chambers for 100-150mm wafers, cassette to casette operation
* Automatic pneumatic soft-lift assemblies for each chamber
* In-line gas filters (0.05 micron)
* Two PM 732 automatch networks
* Quartz halogen lamp for preheating
* Process capabilities: positive and negative resist, hardened resist, polyimide
Process control and instrumentation
* Microprocessor controller, menu driven
* Programmable Process Parameters: Gas Flow, Chamber Pressure, RF Power, Strip time, Heat Lamp On time, overstrip time
* Programmable Tolerance Limits: RF Power (forward and reflected), Time, Pressure, Gas flow, Pumpdown
* Programmable tolerance limit alarm
* Sixty four key, alphanumeric keypad for entry of process and system parameters
* seventy two hour battery backed RAM for program memory
* Two process gas lines and one purge line to include: One O2 @ 4000 SCCM mass flow controller, Optional gas (blank), fast and slow N2 purge
* All Stainless steel valves and gas lines
* Automatic variable throttle valve for pressure control
* Separate capacitance manometers for each chamber with isolation valve
* Two elevator cassette stands for send-to-receive operation
* Distributes AC/DC power to system
* AC ON/OFF for system power, RF generator, and vacuum pumps
* 510 Power Distribution Module
* Separate control for system power, RF generator, and vacuum pumps control signal
* Shielded high-voltage components
* 12-VAC control to complete system
* ENI Mod.-12A RF Generator, 13.56MHz, crystal controlled, 0-1000 watts, continuously rated, Solid state, water-cooled
* Electronic and software interlocks for RF power, wafer heating and gas flow
* Compressed air: 60 to 120 psig (clean and dry)
* System Electrical power: 200 to 240VAC, 40 amp, 1 phase, 50/60 Hz
* Wafer Heating power: 200 to 240VAC, 15 amp, 1 phase, 50/60 Hz
* Cooling water: 1.2 gal/min (house water, filtered) for RF generator
* House vacuum: at leastg .8CFM @ 20 inches Hg
* Mainframe air exhaust: 4 inch duct flange, 100 CFM





Branson ipc L3200 from ALLWIN21