HARIG AIR-FLO FIXTURE MODEL 5C A
* Used for sharpening end mills and milling cutters on a surface grinder. It converts your surface grinder to a tool and cutter grinder!
* The Model 5C A uses 5C collets and does not require bushings. The capacity ranges from 1 1/6†to 1 1/16â€, depending on what capacity 5C collet you use.
* The air flow cylinder floats on a .0001 film of air. You can use any shop air compressor line with 25/100 pounds of pressure.
* It has a direct reading “clearance-angle collarâ€. Makes angular settings easy.
* Swivels universally for radial relief sharpening.
* It has a graduated base for swiveling to angles.
* It has a graduated micrometer thimble which gives instant fine adjustment to the “finger†(Up or down) for determining clearance angle.
Overall dimensions 16†x 6†x 5â€