Iowa-Industrial Moderated Mailing List -- Current and Archive   >   Tristate Area   >   Metalworking and Production   >   Numberically Controlled Equipmnent   >   Milling   >   Microchip 12C508A 04 microcontroller (99P post uk)

Microchip 12C508A 04 microcontroller (99P post uk)


Poster: 656895674@iowa-industrial.com

Microchip 12C508A 04 microcontroller (99P post uk)

MICROCHIP 12C508A 04 MICROCONTROLLER IC.
STOP PRESS: STOP PRESS: STOP PRESS:
A programming service is now available from me and if you require this chip or any other programmable that I sell ( or one of your own ) to be programmed please contact me for details. I offer a speedy turnaround service plus discount prices for quantities. Most programmable DIL chips catered for such as PIC's, GALS, EEPROMS & UVEPROMS plus quite a few other microcontrollers. List available here at my website. /downloads/top2005devicelist.txt
Here are the 12C508A features;
• Only 33 single word instructions to learn
• All instructions are single cycle (1 ms) except for program branches which are two-cycle
• Operating speed: DC - 4 MHz clock input DC - 1 ms instruction cycle
• Seven special function hardware registers
• Two-level deep hardware stack
• Direct, indirect and relative addressing modes for data and instructions
• Internal 4 MHz RC oscillator with programmable calibration
• In-circuit serial programming
A FULL DATASHEET WITH PROGRAMMING / PERIPHERAL INFORMATION IS AVAILABLE AT THE MICROCHIP (TM) WEBSITE
You can pay me instantly with Nochex by clicking the link below.





Microchip 12C508A 04 microcontroller (99P post uk)